Ok, so if ya'll have been following my build progress, I just got the new HP SAS Expander. Previously I had the LSI Controller connected to 2 of my backplanes, and the other backplanes connected via reverse breakout cables. Since I just got the expander, I connected all the backplanes to it. Now only the 2 backplanes that were originally connected via SAS are being detected by DrivePool. The other 4 backplanes aren't being detected in DrivePool, but they do show up in Device Manager and Scanner. I just tried to uninstalled DrivePool and reinstall it, in the hopes that maybe that would rebuild the pool, but that didn't work. Any ideas?
Question
hansolo77
Ok, so if ya'll have been following my build progress, I just got the new HP SAS Expander. Previously I had the LSI Controller connected to 2 of my backplanes, and the other backplanes connected via reverse breakout cables. Since I just got the expander, I connected all the backplanes to it. Now only the 2 backplanes that were originally connected via SAS are being detected by DrivePool. The other 4 backplanes aren't being detected in DrivePool, but they do show up in Device Manager and Scanner. I just tried to uninstalled DrivePool and reinstall it, in the hopes that maybe that would rebuild the pool, but that didn't work. Any ideas?
Link to comment
Share on other sites
8 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.