Possible to display total disk % scanned in status?

[Jaga]

It would be nice to switch the % scanned status in the GUI from an incremental % to a total drive %.  I can't currently see a way to do this, unless it's in the JSON file(s).  I didn't see a setting in there that wasn't exposed, but admittedly I didn't go through all 73 files.   

[Christopher (Drashna)]

Nope, there isn't a way to do, because of how the surface scans are ran. 

The scans are stored as a sector map, so it tracks the regions of the disk.
https://stablebit.com/Support/Scanner/2.X/Manual?Section=Disk Scanning Panel#Sector Map

 

[Jaga]

Ah well, was worth asking.  You'd think with a little math (scanned sectors / total disk sectors) it could convert.  But I haven't seen the code, so I trust your evaluation of it.