Aeonlu Posted October 23, 2024 Posted October 23, 2024 On one of my usb enclosures, after a rebook the drives info, history settings all get mixed up. Windows has no issues keeping the drive letters correct and their names, but scanner mixes them up entirely. Any ideas how to fix? Quote
0 Christopher (Drashna) Posted October 23, 2024 Posted October 23, 2024 Well, it's because different things are being tracked. The Volume ID is how Windows identifies which volume gets which letter. And this shouldn't change. As for identifying the disks, that depends on information about the drives, from the USB controller, which could change. It may be best to to open a ticket at https://stablebit.com/Contact for this. But, specifically, if you can run the StableBit Troubleshooter twice, once before rebooting, and once after rebooting, where the information has gotten mixed up. https://wiki.covecube.com/StableBit_Troubleshooter And make sure the "Include disk details" option is enabled (it should be by default for StableBit Scanner, but just to make sure). And use either the Contact ID from that ticket, or "27507" for the contact ID, in StableBit Troubleshooter. Quote
0 Aeonlu Posted November 11, 2024 Author Posted November 11, 2024 I have submitted the ticket. Thanks Quote
Question
Aeonlu
On one of my usb enclosures, after a rebook the drives info, history settings all get mixed up. Windows has no issues keeping the drive letters correct and their names, but scanner mixes them up entirely. Any ideas how to fix?
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.