If I have multiple S.M.A.R.T. warnings on a disk, how do I ignore some of them permanently, while I ignore just the current warning for other types?
If anyone cares, I have WD Green disks "suffering" from IntelliPark so the Load Cycle Count is off the charts. At the same time one of the disks have 1 problematic sector. I don't care if LCC goes from 492612 to 492613, but I want to know if the sector count goes from 1 to 157 or even 2. I just can't figure out how to make StableBit Scanner do that for me.
Question
mate
If I have multiple S.M.A.R.T. warnings on a disk, how do I ignore some of them permanently, while I ignore just the current warning for other types?
If anyone cares, I have WD Green disks "suffering" from IntelliPark so the Load Cycle Count is off the charts. At the same time one of the disks have 1 problematic sector. I don't care if LCC goes from 492612 to 492613, but I want to know if the sector count goes from 1 to 157 or even 2. I just can't figure out how to make StableBit Scanner do that for me.
Thanks in advance.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.