Ignore S.M.A.R.T. Warning - some Current, some Permanently?

[mate]

If I have multiple S.M.A.R.T. warnings on a disk, how do I ignore some of them permanently, while I ignore just the current warning for other types?

 

If anyone cares, I have WD Green disks "suffering" from IntelliPark so the Load Cycle Count is off the charts. At the same time one of the disks have 1 problematic sector. I don't care if LCC goes from 492612 to 492613, but I want to know if the sector count goes from 1 to 157 or even 2. I just can't figure out how to make StableBit Scanner do that for me.

 

Thanks in advance.

[Christopher (Drashna)]

That's a good question... 

Unfortunately, there isn't a good way to do this at the moment. And that is something that we should see about fixing.

 

For now, just ignore them temporarily. One the LCC count increases, then ignore that permanently.

 

Requested here:

https://stablebit.com/Admin/IssueAnalysis/13516