I've been upgrading my storage this week and had installed the latest available beta from the website (2.2.0.881) so I could swap disks without the pool going into read-only mode. Since installing the beta I've noticed an occasional error in my system log - Event ID 153, logged to "disk", with the following: "The IO operation at logical block address 0x2 for Disk 10 (PDO name: \Device\00000045) was retried."
In this case Disk 10 is the drive hosting the pool. I hadn't seen this come up with the previous DrivePool install. Is this anything to be concerned about? It seems to happen after a reboot but not always.
Question
DaveJ
I've been upgrading my storage this week and had installed the latest available beta from the website (2.2.0.881) so I could swap disks without the pool going into read-only mode. Since installing the beta I've noticed an occasional error in my system log - Event ID 153, logged to "disk", with the following: "The IO operation at logical block address 0x2 for Disk 10 (PDO name: \Device\00000045) was retried."
In this case Disk 10 is the drive hosting the pool. I hadn't seen this come up with the previous DrivePool install. Is this anything to be concerned about? It seems to happen after a reboot but not always.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.