Jump to content
Covecube Inc.

Search the Community

Showing results for tags 'scanning histories'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Covecube Inc.
    • Announcements
    • Nuts & Bolts
  • BitFlock
    • General
  • StableBit Scanner
    • General
    • Compatibility
    • Nuts & Bolts
  • StableBit DrivePool
    • General
    • Hardware
    • Nuts & Bolts
  • StableBit CloudDrive
    • General
    • Providers
    • Nuts & Bolts
  • Other
    • Off-topic

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Last night, I decided to upgrade from Scanner 2.5.1.3062 (wssx) to Scanner 2.5.4.3216 (exe). At first, the install failed and told me I needed to UN-install the prior version before I could proceed with the upgrade to 2.5.4.3216 (exe). So I did this from the Dashboard (Remove Add-in). Afterward, it did not ask me to reboot, so I didn't, thinking my current configs would more likely be preserved than if I did. The RE-Reinstall went OK with no errors and it reported the install as "Successful". After running the new version for the first time, I immediately noticed that ALL (100%) of my Disk Settings were GONE - the Custom Names and Locations, which I had painstakingly created so I could tell my disks apart from one another. This is important, since (1) I have 27 Disks, (2) most of my disks are WD Reds and (3) my old Supermicro PCI-X controllers are not reporting the correct serial numbers using the Sonnet driver I must use with them to allow disks greater than 2TB. I have always relied on Scanner to be able to locate the correct Disk that might need to be removed! I would seriously like to NOT have to go through that whole process again, SO ... is there any way to recover this information BACK into Scanner? PLUS, I am concerned that this is now going to happen every time I upgrade to a newer version. Is it? Thanks in advance for any help you might be able to provide. Really appreciate it! Gary
×
×
  • Create New...