Search the Community
Showing results for tags 'probox scanner crashes'.
-
Hi, I have the following set-up: WHS 2012 Essentials running on N54L HP microserver. ProBox 8-Bay is connected via USB 3.0 connected to a TI USB 3.0 PCIe card in the N54L. I have drive pool running on a Pool containing 6 drives from the ProBox 8-Bay. I have noticed in the past that programs like speedfan (upon initial boot-up and probing for SMBUS devices and performing SMART reads) would cause the ProBox to disconnect and reconnect. This was an annoyance because the drivepool would start re-checking the whole 19TB pool and waste electricity. So, I started using hard disk sentinel to perform SMART monitoring and had no issue. When the speedfan problem happened, I had filed in the probox forum and the support folks recommended the software. ProBox support had also indicated that this was a speedfan known issue and I could also use HD Tune instead for free; though, I could not do live monitoring. Anyways, I had to chose to spend money on "hard disk sentinel" or stablebit scanner and due to my good experience with the drivepool, I decided to buy the stablebit scanner without doing a trial. Why no trial? Well, I tried to use the trial and kept on asking for trial license even before ever using it. I gave up trying to fix that issue and just paid the $15 to try to complete my task by this weekend. Well, stablebit scanner now causes the USB 3.0 ProBox to disconnect and reconnect every time if does this burst of SMART scanning. If I do individual scans of the HDD, then there is no issue but somehow when the stablebit scanner does things automatically, it causes a disconnect/reconnect. When that happens, the drivepool starts re-checking the whole single POOL again and I have been stuck in this issue for the past 24 hours. Any thoughts or ideas to fix this issue? I have reviewed the advanced stablebit scanner settings but I am not sure which one may help to fix this specific issue. Thanks,