KgCobra1
-
Posts
7 -
Joined
-
Last visited
Posts posted by KgCobra1
-
-
I had a drive that was reporting this error. I was able to successfully remove the drive, replaced it with a brand-new enterprise drive. It added successfully and files loaded properly. Now when I am moving files into the pool, I am getting this same error on the new drive (using the same bay). I have tried manually putting files into the pool in and get the same error.
I also tried to remove another drive in my setup and DrivePool is now reporting this error on this drive as well. Hard to believe I have 3 bad drives. Is it possible DrivePool has a filesystem error?
I have ran chkdsk on both the original drive, new drive, and 3rd drive that I tried to remove from the pool and all reported no errors or bad sectors.
I am out of options here.
Andrew
-
Ticket submitted. 5311649
-
I'm not sure I understand your reply. Do I need to go to another forum to see the results of the Troubleshooter that I sent you? What "ticket" you are referring too other than this inquiry?
-
Just was able to finally get to your request and completed the troubleshooter successfully.
-
Thank you for the quick response.
Once the Scanner gave me the first file system error message, I ran CHKDSK and it didn’t report any errors. I also put it into another system and ran CHKDSK again without errors. Once I confirmed the disc was fine, I put it back into the array and cleared the errors manually. This is when I noticed that it was still reporting the previous disc size. I reset all drives in Scanner, it scanned all discs fine and reported no errors, however the size never changed. I have attached screenshots:
Capture.jpg - Reported size in Disk Management
Capture1.jpg - DrivePool reported info
Capture2.jpg - Scanner reported info
Capture3.jpg - C:\Mounted Disc info
-
Hello,
I recently replaced a HD in my Mobius USB 3.0 5 Bay Array. DrivePool is all good and balancing is fine. However, StableBit Scanner scanned it with errors in the file system. However, I noticed that the HD specs and size are still showing the replaced HD information and size. I tried to to reset all discs and rescan without any change.
I appreciate any quick response. Thank you.
System.IO.IOException: The drive cannot find the sector requested.
in General
Posted
Hey there,
The error I was getting was apparently coming from a faulty controller in my enclosure. I ended up having to replace it and the issue was resolved after putting in a ticket and Chris was able to help me determine this.
Good luck.