Hello. I have DrivePool working great on my server and am in the process of getting Scanner configured. After the initial installation all my drives are seen by Scanner, but I'm not getting the SMART info to pass through.
Here is my setup:
3 local drives (Sata) (SMART info is showing on each)
24 local drives connected to an Areca ARC-1680ix-24 controller with BIOS 1.51.
38 external drives connected from 2 systems, each with an HP SAS expander connected to a 2nd local Areca ARC-1680ix-16 controller with BIOS 1.51
Both controllers are set to JBOD and both have the SMART polling currently set to 30 minutes.
When I look at any of the 62 drives connecting via the Areca controllers, they all slow "The on-disk S.M.A.R.T. check is not accessible. Drive temperature and mechanical operating parameters are not available and will not be monitored."
Question
vorpel
Hello. I have DrivePool working great on my server and am in the process of getting Scanner configured. After the initial installation all my drives are seen by Scanner, but I'm not getting the SMART info to pass through.
Here is my setup:
3 local drives (Sata) (SMART info is showing on each)
24 local drives connected to an Areca ARC-1680ix-24 controller with BIOS 1.51.
38 external drives connected from 2 systems, each with an HP SAS expander connected to a 2nd local Areca ARC-1680ix-16 controller with BIOS 1.51
Both controllers are set to JBOD and both have the SMART polling currently set to 30 minutes.
When I look at any of the 62 drives connecting via the Areca controllers, they all slow "The on-disk S.M.A.R.T. check is not accessible. Drive temperature and mechanical operating parameters are not available and will not be monitored."
Any help would be greatly appreciated.
Thanks,
dc
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.