Using Snapraid

[Bradleyb]

I started using drivepool today and found it very easy - no problems yet.    But I do have two questions for those more informed than I am. 

1) I'm also going to use snapraid and I assume when I configure that, I add the individual data drives to it and never the pool drive created by drivepool?

2) I have five-drives with existing media on each drive that I added to the pool.    Would it be best to copy the media to the new drive (which might take a while) or can I just copy the media from each drive into the poolpart folder on each drive? There is one root folder \media and two sub-folders \media\movies \media\tv which show up in one poolpart folder so if I re-create those on each data drive, would that case a problem?

Thank you for any suggestions and information.

[Bradleyb]

Found this in case it helps anyone else - 

http://wiki.covecube.com/StableBit_DrivePool_Q4142489

Sounds like it wouldn't be best just to copy a lot of data from the pooled drives that's outside of the poolpart folder into the poolpart folder without stopping the service first and then resetting settings.