I recently installed an Orico 4 bay external hard drive RAID enclosure as JBOD and moved one existing drive from my drive pool from a USB caddy to the first bay in the device. It sees the drive OK but in StableBit Scanner reports it as 115 PB (nice if true!) rather than 3TB (2.73TB actual in Scanner).
The Disk Sectors showed as unscanned and were clear rather than green. I tried the check but it would not run. I set File System Health to Good as I had checked it only last week, did a reboot and now the sectors all show green.
The DrivePool has removed all data from the drive and it now shows in Disks as [284MB / 2.73 TB]. It was also showing when hovering over it as Limited Use (or words to that effect) and had a small blue and red triangle above and below it. It no longer does so but shows the drive is clearly not being used in Disks.
Question
MrBlond
I recently installed an Orico 4 bay external hard drive RAID enclosure as JBOD and moved one existing drive from my drive pool from a USB caddy to the first bay in the device. It sees the drive OK but in StableBit Scanner reports it as 115 PB (nice if true!) rather than 3TB (2.73TB actual in Scanner).
The Disk Sectors showed as unscanned and were clear rather than green. I tried the check but it would not run. I set File System Health to Good as I had checked it only last week, did a reboot and now the sectors all show green.
The DrivePool has removed all data from the drive and it now shows in Disks as [284MB / 2.73 TB]. It was also showing when hovering over it as Limited Use (or words to that effect) and had a small blue and red triangle above and below it. It no longer does so but shows the drive is clearly not being used in Disks.
How do I correct the drive size?
Will it start using the drive again for me?
Note:
* Current status
* Drive letter O:
Link to comment
Share on other sites
16 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.