Ian Spencer Posted April 30, 2018 Share Posted April 30, 2018 I have a USB3 4 Bay older Orico external bay works no issues but new once NS800U3 lists drives under name as JMicron Generic DISK0X USB Device each one starting at DISK00 to DISK07. All the smart Data seems fine including drive model number. Scanner V2.5.1.3062. I realise you can rename them manually but would be good if you could look into this. Also if it interests anyone The enclosure runs a lot hotter after 30 min or minimal activity I get temp alerts. Temperature runs at 46 Deg C compared to 37 Deg C compared to older enclosure for same model 8TB Seagate drive, I bumped the alerts up to 48 Deg. Not sure what the max recommended temp is but clearly these enclosures just are not very efficient cooling. It only has 5 drives out of 8 in so far. About half the volume of air coming out of rear compared to older 4 Bay Orico. Quote Link to comment Share on other sites More sharing options...
Christopher (Drashna) Posted May 1, 2018 Share Posted May 1, 2018 StableBit Scanner is pulling what the system says the name is. So, the inclosure is modifying the name, and sending that. As for the temperature: http://stablebit.com/Support/Scanner/2.X/Manual?Section=Heat And you can set them individually. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.