Jump to content
  • 0

Stablebit Not Detecting New Disks


dsniesen

Question

I have been playing around with Stablebit for little over a month and I continue to run into the same problem.  Adding new disks rarely show up in the disk list or some are skipped entirely.  I will have 10 drives in and stablebit will skip over a few of them, such as disk 4,5,8. 

 

I usually average about 3-5 drives in my array that are detected by the OS but not stablebit. 

 

Any advice would be greatly appreciated

 

Thank you. 

 

Link to comment
Share on other sites

3 answers to this question

Recommended Posts

  • 0

What do you mean "skip"? 

 

As they don't show up in the list at all?  

Or they don't scan the disks?  

Or...?

 

 

That said, if these are CloudDrive disks, the surface scan is automatically disabled (otherwise, it would force downloading the entire content of each drive every month).

 

Also, check to make sure that the scanning isn't disabled in the "Disk Settings" for each disk.

 

And are these ReFS formatted disks?

 

 

Also, could you run this:

http://wiki.covecube.com/StableBit_Troubleshooter

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...