I am almost sure, I am missing something here, but since DP is working so flawlessly in general, I cannot recall if what I see is a problem from my side of the keyboard or from DP.
Did an upgrade to 2.2.0.798 BETA to solve a problem with being unable to temporarily remove a good drive from the pool, as stated elsewhere here in the forums.
After that, DP (re-)gathered all data and everything looked well.
Now, a couple of days and reboots later, I am seeing the effect, that some files are not accessible from the pool.
Explorer sees them, but opening gives an Error, that the file is not there.
I normally don't use the native drives, just the pool...after enabling the disks and accessing the pool-part folders directly, the files are there and can be accessed, as expected.
However, the problem with accessing the files via the Pool persists.
I issued the command to re-gather the pool information manually, several times to no avail.
Since when I enabled the native disks with drive letters, a large part is now shown as "other" instead of duplicated/non-duplicated...don't know if this is related though.
...what is the recommended procedure to get DP up to the correct state and functioning again?
Question
p3x-749
I am almost sure, I am missing something here, but since DP is working so flawlessly in general, I cannot recall if what I see is a problem from my side of the keyboard or from DP.
Did an upgrade to 2.2.0.798 BETA to solve a problem with being unable to temporarily remove a good drive from the pool, as stated elsewhere here in the forums.
After that, DP (re-)gathered all data and everything looked well.
Now, a couple of days and reboots later, I am seeing the effect, that some files are not accessible from the pool.
Explorer sees them, but opening gives an Error, that the file is not there.
I normally don't use the native drives, just the pool...after enabling the disks and accessing the pool-part folders directly, the files are there and can be accessed, as expected.
However, the problem with accessing the files via the Pool persists.
I issued the command to re-gather the pool information manually, several times to no avail.
Since when I enabled the native disks with drive letters, a large part is now shown as "other" instead of duplicated/non-duplicated...don't know if this is related though.
...what is the recommended procedure to get DP up to the correct state and functioning again?
I am on Win10-Pro 64bit BTW.
TIA,
Fred
Link to comment
Share on other sites
22 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.