Hi - I was using Microsoft Synctoy to sync a large number of folders from my local drivepool to the mounted google drive through clouddrive. I was just about to finish the initial sync, and I noticed that the cloud drive was reporting the 'To Upload' as about 60MB, and although it said that it was uploading, the 'To Upload' amount was not dropping as it should. I left if for a few hours yesterday and came back, and it has been stuck at 10MB within 'To Upload' ever since.
I am getting an I/O error that has to deal with cyclic redundancy check (see below screenshot):
I was doing some searching on the forum, and noticed I wasn't on the latest beta, as the version I was using was 1.0.0.631. I updated to version .696, and my problem has persisted, and it is now also stuck on Pinning Data (as per the screenshot as well).
Here is some additional info on my setup:
What OS are you using? (run "winver" to check) - I'm running Windows 10 Pro version 1151 (64bit)
What version of StableBit CloudDrive are you using? (check the bottom of the UI) - .696
What provider are you using? - Google Drive (unlimited storage, even though Cloud Drive shows 10TB limit)
Does the UI have any errors? - See above screenshot.
Additionally, please see attached for the zip file of the attached error (both before and after the upgrade). I had to use dropbox since the sizes were too big for the post.
Question
feerlessleadr
Hi - I was using Microsoft Synctoy to sync a large number of folders from my local drivepool to the mounted google drive through clouddrive. I was just about to finish the initial sync, and I noticed that the cloud drive was reporting the 'To Upload' as about 60MB, and although it said that it was uploading, the 'To Upload' amount was not dropping as it should. I left if for a few hours yesterday and came back, and it has been stuck at 10MB within 'To Upload' ever since.
I am getting an I/O error that has to deal with cyclic redundancy check (see below screenshot):
I was doing some searching on the forum, and noticed I wasn't on the latest beta, as the version I was using was 1.0.0.631. I updated to version .696, and my problem has persisted, and it is now also stuck on Pinning Data (as per the screenshot as well).
Here is some additional info on my setup:
What OS are you using? (run "winver" to check) - I'm running Windows 10 Pro version 1151 (64bit)
What version of StableBit CloudDrive are you using? (check the bottom of the UI) - .696
What provider are you using? - Google Drive (unlimited storage, even though Cloud Drive shows 10TB limit)
Does the UI have any errors? - See above screenshot.
Additionally, please see attached for the zip file of the attached error (both before and after the upgrade). I had to use dropbox since the sizes were too big for the post.
https://www.dropbox.com/s/t6qkcsgcqh7yz2w/Service%20-%20696%20Beta.zip?dl=0
https://www.dropbox.com/s/356m9h6aqohzs0j/Service%20-%20Older%20Beta.zip?dl=0
Link to comment
Share on other sites
14 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.