I have just found out that if powering off my system or removing my HDDs all "disk control" settings (AAM, APM and standby timer) get resetted.
This is bad, because the defult load/unload cycle is just a few seconds with no standby, so this will wear out the HDD quite fast.
Is it possible to implement a feature, which would reload the disk control settings (at the start of the Scanner service or when a new HDD is detected) for HDDs which are not able to save the disk control settings?
Because there is no program which could reload the settings (in Windows at least) , this could be a unique selling point for the scanner
Question
Wonderwhy
Hey,
I have just found out that if powering off my system or removing my HDDs all "disk control" settings (AAM, APM and standby timer) get resetted.
This is bad, because the defult load/unload cycle is just a few seconds with no standby, so this will wear out the HDD quite fast.
Is it possible to implement a feature, which would reload the disk control settings (at the start of the Scanner service or when a new HDD is detected) for HDDs which are not able to save the disk control settings?
Because there is no program which could reload the settings (in Windows at least) , this could be a unique selling point for the scanner
Regards,
Wonderwhy
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.