Been using Drivepool and Scanner on two machines for a little while now and it's great. However, I've noticed that I cannot use the remote management on either local machine to look a the other remote machine status.
The drop-down list at the top of the Drivepool window (same applies to Scanner actually) only shows the local machine, and not the remote one. I have tried disabling all firewalls, but still no luck. Multicasting/Broadcasting is not blocked on my router either - only have packet-storm protection at 10Mbps or higher.
Any ideas? Both machines run Win7 Ultimate 64-bit.
Question
Chris Downs
Hi,
Been using Drivepool and Scanner on two machines for a little while now and it's great. However, I've noticed that I cannot use the remote management on either local machine to look a the other remote machine status.
The drop-down list at the top of the Drivepool window (same applies to Scanner actually) only shows the local machine, and not the remote one. I have tried disabling all firewalls, but still no luck. Multicasting/Broadcasting is not blocked on my router either - only have packet-storm protection at 10Mbps or higher.
Any ideas? Both machines run Win7 Ultimate 64-bit.
Chris
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.