Search the Community
Showing results for tags 'reboot'.
Found 3 results
-
Any way to change the measure-on-every-reconnect behavior?
jenesuispasbavard posted a question in General
So I've recently switched from a desktop setup with 3x 8TB HDDs storage and 1x 128GB SSD cache, to a laptop + eGPU setup with the same four drives in an external enclosure connected to the eGPU. Laptop is connected to eGPU through a single Thunderbolt 3 cable for charging and data, and the enclosure is connected to the USB-C port on the graphics card. Every time I shut down and turn on my laptop, or if I disconnect the TB3 cable and plug it back in (so basically every day after coming home from work), Drivepool starts measuring my entire 22TB pool from scratch, so I just have to wait -
Hey Guys - For the past couple of months, I've had an issue which I found out today only occurs with network file shares that are on my drive pool. I am able to connect to these file shares just fine as well as read from them, however; if i try to write to them or edit a file within one, the workstation (system that hosts the share) immediately bluescreens, bugchecks, dumps, then restarts. I run both DrivePool 2.2.0.906 as well as Scanner which scans as needed at night. I have all performance options enabled except for "Bypass file system filters" plus use the SSD plugin. Balanc
-
How do I get CloudDrive to forget my encryption key after a reboot?
blaineeasy posted a question in General
I must have accidentally checked the box that stores the encryption key because now CloudDrive mounts my drive when the machine boots up (even after a full shutdown). How do I tell it to ask for my key again at startup? Thanks.
