[[Solved] Got extra drive, pool went nutty.]

On 12/9/2017 at 11:40 PM, Christopher (Drashna) said:

It sounds like it errored out when setting up the pool.  The "Sequence" error may have been directly related, then. 

If this hasn't been resolved yet, then do this: 
http://wiki.covecube.com/StableBit_DrivePool_F1655

It was sorted, but thanks

[[Solved] Got extra drive, pool went nutty.]

21 hours ago, britgeezer said:

Drashna has referred you to your ticket.

I can tell you you made an add selection option mistake, you selected add new pool instead of add to pool.

I made the same mistake myself a while back.

Answer is delete the new pool and add to existing.

I made no mistake, the add new pool button isn't even near the add disk one. The software looked like it tried adding it to my old pool but after a few seconds it would just create a new pool instead with the disk selected. Repairing my install made DrivePool function as normal again.

[[Solved] Got extra drive, pool went nutty.]

My problem is kinda two fold. I just bought a new USB drive and tried to add it to my existing 5 drive pool which resulted in drivepool creating a separate pool for some reason. Then I tried removing one of my drives from the original pool but cancelled once it started migrating data and now I can no longer change balancing settings due to the following error:

 

"Error Saving Settings

Sequence contains no elements"

 

Any chance you lads can help me out?