akshoslaa

Has anyone else experienced the UI hanging? (2.0.0.260)
 
I recently switched to DrivePool, While importing all of the data from each disk into the pool, I turned off balancing to stop it from shifting stuff between disks until I was done. Once all the data on the disks was on the pool, I kicked off a manual balance, the next morning I found the UI hung. according the the image the balancing looked as though is was complete, but I couldn't interact with the software at all.
 
Killed the process, and relaunched - the process starts, but nothing comes up on the screen. Tried a service restart - no change. Reboot - UI was working normally again.
No other problems (aside from the srv2.sys BSODs) for the next few days, until I went ot remove a disk that was shown with a SMART warning. Removal ran overnight, and in the morning - the UI had hung again, the same symptoms as before. Haven't rebooted yet - so I can't access the UI, but I can confirm it completed the removal of the disk from the pool.
 
In both of these cases it was a long running, intensive process that was the last action I took before it hung. I'm fairly certain (but not 100%) that I'd left the UI open for an extended period _without_ running any task, and hadn't experienced a hang.
 
Performance Tab was not expanded at the time of the hang.