I have been trying to get a manual check performed on one of my disks in my drivepool, but it doesn't seem to do anything. Specifically, I'm expecting a surface scan, but when I click start, it goes grey, and after a few seconds becomes click-able again, but nothing seems to happen.
I thought perhaps the work window was interfering, so I have set it to allow work at any time, but it still doesn't do anything. Should a manual check include a surface scan, or am I expecting something that it doesn't do from a manual start?
Question
JasonC
I have been trying to get a manual check performed on one of my disks in my drivepool, but it doesn't seem to do anything. Specifically, I'm expecting a surface scan, but when I click start, it goes grey, and after a few seconds becomes click-able again, but nothing seems to happen.
I thought perhaps the work window was interfering, so I have set it to allow work at any time, but it still doesn't do anything. Should a manual check include a surface scan, or am I expecting something that it doesn't do from a manual start?
Thank you
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.